Qualitative Analysis: Flame Tests
Some metal ions produce characteristic visible colours when introduced into a flame. Heating excites electrons; as they return to lower energy states, atoms or ions emit light at characteristic wavelengths. Observed flame colours are a useful screening test, but they are not always sufficient for definitive identification.
Reference flame colours
Li⁺ — crimson redNa⁺ — intense yellowK⁺ — lilacCa²⁺ — orange-redSr²⁺ — scarlet redBa²⁺ — apple greenCu²⁺ — blue-green
Colours vary with sample composition, viewing conditions and contamination. Copper salts can show blue-green emissions; the exact colour depends on chemical species.
Why controls matter
A clean loop and blank test help distinguish sample emissions from contamination. Sodium contamination is particularly common and its strong yellow emission can obscure weaker colours.
Actual laboratories use approved materials, eye protection, ventilation, and instructor-supervised procedures. This simulation uses no flame or chemicals.
Learning goals
- Record qualitative observations using precise colour descriptions.
- Match an unknown to reference observations and state the strength of the evidence.
- Explain electron excitation and emission and identify sources of error.
Print or save the assignment, perform the virtual lab, record observations and complete your lab report.
Student Assignment
Research question: How reliably can characteristic flame colours be used to identify an unknown metal ion?
- Run the blank control with a clean loop. Record its appearance.
- Test at least five known metal-ion reference samples with a clean loop and record the colour for each.
- Investigate two coded unknowns. Compare their colours with your reference observations.
- Repeat an unknown using a contaminated loop. Explain the change, then clean the loop and retest.
- Use the Data & Graphs tab to review observations and export your table.
- Complete the Lab Report, including evidence, limitations and a conclusion.
Variables
Independent variable: metal-ion sample. Dependent variable: observed flame colour. Controlled conditions: simulated burner, observation setting, and cleaning procedure.
Unknowns are fixed for this browser session until “New unknown set” is selected. They are drawn from the seven listed reference ions.
Interactive Flame-Test Bench
Educational colour illustration, not a physical flame model or emission spectrum. Colour perception differs across screens.
Observations & Graphs
0 observations recorded.
| Trial | Sample | Loop | Observed colour | Interpretation |
|---|
Reference observations by colour family
Counts describe recorded observations, not flame intensity or chemical concentration. Unknowns are included according to the colour observed.
Student Lab Report
Work saves automatically in this browser. Export a JSON draft for backup or moving devices.
Teacher Resources
Suggested duration: 45–60 minutes. Assessment: formative or evaluated practical report.
Suggested KTCA rubric (20 marks)
| Category | Marks | Criteria |
|---|---|---|
| Knowledge | 5 | Correct electron-transition explanation and colour terminology |
| Thinking | 5 | Reasoned identification, control selection and uncertainty |
| Communication | 5 | Clear data table, appropriate terminology and conclusion |
| Application | 5 | Connects results to qualitative analysis and proposes confirmation |
Teaching guidance
- Students should identify unknowns using clean-loop observations; contamination trials demonstrate interference.
- Li and Sr both appear red; visual discrimination is imperfect. Flame tests alone cannot unambiguously identify every mixture.
- Confirmatory methods include emission spectroscopy and complementary wet-chemical tests where appropriate.
- Simulation is qualitative, simplified, and not calibrated to measured emission spectra or real sample concentration.
- All work is stored locally; no login or external service is required.