1. Virtual Labs
  2. Kinesiology
  3. Biomechanical Analysis of a Sport Skill
⬇ Assignment (PDF)
WorksheetGalaxy / Virtual Science Labs

Biomechanical Analysis of a Sport Skill

PSK4U · Grade 12 Introductory Kinesiology · Virtual laboratory · Approx. 45–60 minutes

Biomechanics of a ball throw

Biomechanics applies physics to human movement. In an overhand throw, coordinated movement through the legs, trunk, shoulder, elbow and wrist transfers energy to a ball. Release speed, release angle and release height influence its flight. This lab models the ball after release, not the forces within the athlete's joints.

In an idealized projectile model with no air resistance, horizontal velocity stays constant and vertical velocity changes due to gravity (9.81 m/s²). At a fixed release height, different combinations of speed and angle produce different flight distances.

Equations: x(t) = v cos(θ)t; y(t) = h + v sin(θ)t − ½gt². The landing time is the positive solution to y(t) = 0. Range = v cos(θ) × landing time.

Release speed depends on the athlete's technique, muscular force and coordination. Joint-angle observations can be useful, but a single elbow or shoulder angle does not determine ball speed or injury risk.

Model limitation: This is a simplified two-dimensional projectile model, not a full human movement simulation. Air resistance, spin, wind, ball size, ground slope and biomechanics of the throwing arm are omitted. The model assumes an unobstructed flight and level landing surface.
Download student assignment (PDF)

Print or save the assignment, perform the virtual lab, record observations and complete your lab report.

Investigation: How does release technique affect throw distance?

Research question: How do release angle and release speed affect the horizontal distance of a ball thrown from a constant height?

  1. Write a hypothesis identifying the independent, dependent and controlled variables.
  2. Set release height to 1.8 m and speed to 15 m/s. Run throws at 20°, 30°, 40°, 45°, 50° and 60°. Record each trial.
  3. Keep angle at 40° and height at 1.8 m. Compare release speeds of 10, 15 and 20 m/s.
  4. Compare the plotted trajectories and graph the recorded trials.
  5. Identify the longest throw in your trials and explain the result using projectile motion.
  6. Discuss at least two reasons why a real athlete might not reproduce the simulated result.

Change one variable at a time for a fair test. The built-in calculations are theoretical predictions, not measurements of real throws.

Throw controls

Adjust the settings, then run a trial.

Predicted results

Range—
Flight time—
Maximum height—

All values are calculated using ideal projectile equations.

Ball trajectory

Horizontal distance (m) versus height above ground (m). The ball starts at the selected release height.

Recorded trials

TrialAngle (°)Speed (m/s)Height (m)Range (m)Flight (s)Peak (m)
No trials yet.

Throw distance by trial

Student Lab Report

Drafts are stored in this browser. Export a JSON backup before clearing browser data.

Results appendix

Recorded trial data will appear here.

Teacher Resources

Learning goals: Explain projectile motion, distinguish independent and dependent variables, interpret a graph, and evaluate limits of a simplified model.

Suggested KTCA rubric (20 marks)

CategoryEvidenceMarks
KnowledgeCorrect explanation of release angle, speed and projectile motion5
ThinkingControlled comparisons, hypothesis and interpretation5
CommunicationClear data table, graph and lab report5
ApplicationRelating simulation to actual movement and limitations5

Reference discussion

At the same release speed and height, an intermediate release angle generally gives the longest range. When the release height is above the landing surface, the ideal optimum angle is slightly below 45°. Increasing speed increases range substantially. The model cannot predict how an athlete's release speed changes with angle.

Accessibility: All controls use native buttons and sliders. Charts have accompanying numeric data in the table.

Assessment caution: Simulated results should not be represented as experimentally collected measurements.

More Grade 12 Introductory Kinesiology labs

Free interactive labs with printable assignments. All kinesiology labs →

© WorksheetGalaxy · Free virtual science labsAll virtual labsSample lab reportAboutPrivacyContact